INBXX angled PTFE passthrough, PTFE holder

Both of these should lineup with A2 version of INBXX.
Chapter names contains links to the onshape project files.

Small angled PTFE passthrough:

Passthrough is angled 25° to shorten the bend radius and hardmounted to stop it poping out of the hole.

BoM:

• 2x M3 hex nut (or Nyloc nut)

• 2x at least M3x8

Assembly:

• Pull M3 nuts from behind of inner part (the one with hex cutout)

• To route the tubes the "right" way line the passthrough with either locator pin orPTFE holes (on the outer side) at the top

• Secure with M3 screw

PTFE holder:

BoM:

• 4x M3 hex nut (or Nylock nut)

• 4x M3x10

Assembly:

• Pull M3 nuts from behind into holder

• Secure holder with 2x M3 screws and nuts to the back panel

• Route PTFE tubes and secure the cover with 2x M3 screws