Skip to main content
F3D
Bộ ổn định ăng-ten cho Portapack 1

5 images

DIY

Bộ ổn định ăng-ten cho Portapack

By Smokintbird_78753

Likes
1
Views
51

Files 2 99.2 KB

  • HackRF_Portapack_Antenna_Saver_v.3_-_Comet_1774645711.stlSTL · 46.4 KB
  • HackRF_Portapack_Antenna_Saver_v.3_-_Generic_1774645711.stlSTL · 52.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#264380
Category
DIY
Published

Description

When "whacked" or "struck" from the side, this spreads the load across a much wider area of the top cover... HOPEFULLY saving me from a broken case!

  • BNC-Female to SMA-Male adapter and Comet BNC-W100RX antenna

    • This version can be TIGHT, and needs to be snapped in to place around the antenna and adapter
  • BNC-Female to SMA-Male adapter to work with most other BNC connector antennas.

I made sure to tighten the retaining nut on the portapack's SMA connector before screwing this in, since that will aid in load distribution as well.

Mine are printed in PolyCarbonate, since that is what the clear housing on my portapack is made from.

Should NOT require any supports on most printers, in most materials.

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
99.2 KB
Largest file
52.8 KB

0 comments

See all