
Ống thoát khí kèm bộ lọc Centauri Carbon 2
Remix of Ống xả Elegoo Centauri Carbon 2 (Exaust Pipe) - tuỳ chọn fan/duct/HEPA By ShePrintsSan_4243391
- Downloads
- 6
- Likes
- 0
- Views
- 76
- Remixes
- 0
- Comments
- 0
Files 2 680.5 KB
- CC2_Exhaust-Vent_1774101072.stepSTEP · 226.3 KB
- CC2_Exhaust-Vent_1774101073.stlSTL · 454.2 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #260510
- Category
- Máy In 3D
- Published
- License
- GNU General Public License v3.0
Description
This is the first thing I have modeled, so it may not be the best aswell as my description, but after some testing once it fit my needs, I was done with it. I remixed the model from "ShePrintsSanctuary." I wanted a solution that not only runs straight from the back of the printer but could also use the HEPA filters from "Wolf_Prints" design here https://www.printables.com/model/1245774-centauri-carbon-exhaust-filtervent-2-in-1, which is a remix of Uncle Jessy's filtration part here https://www.printables.com/model/1214432-elegoo-centauri-carbon-hepa-filter. Due to originally following "Wolf_Prints" part list, then adapting what I had to work with the cc2, I used the same filters and vent, which can be found here https://www.amazon.com/Daisypower-Adjustable-Outdoor-Exhaust-Ventilation and here https://www.amazon.com/dp/B0782T7L6P? .
In the areas I have outlined in red, I suggest support. I printed this without calibration on my CC2 in hopes that others can do similar. I may go back and make a gasket, though I use tape anyway, as the panel always ends up not being perfectly square, even with a gasket, likely due to the fact that you have no clamping force on the bottom, as there are no threads on the bottom.
Around 15-20 (default, doesn't matter much) percent infill should be fine, on .42mm wall width, the pipe walls are solid anyway. Printed in elegoo's rapid petg. I did normal supports for peace of mind, and the print did use a brim, which auto-applied. I really tried to keep tuning minimal with this piece.
Print spec
- Formats
- stepstl
- Model files
- 2
- Total size
- 680.5 KB
- Largest file
- 454.2 KB
0 comments
You may also like 12 models
See all-

-

-
New -
New -
New -

-

-

-

-

-

-


