Skip to main content
F3D
Typhoon shroud K1 Series - D3vil Design 1

10 images

Máy In 3D

Typhoon shroud K1 Series - D3vil Design

By D3vilDesign

Downloads
377
Likes
105
Views
2,868

Files 1 16.5 MB

  • D3k1-5015_V6_Typhoon_1773947465.stlSTL · 16.5 MB

Make a variant with AI

Build another version of this model.

Open Studio

Description

apologies for the delay in posting this …

This it a beta Version , kindly do test it and let me know if you have any suggestion ,, ill accomodate them … If you are interested in developing it further please do contact me on Discord @omranello 

the blower can be found at:

 D3vil Aliexpress 
 

 Meltbro.de 
 

PRINT SETTING :

i prefere ASA or ABS  use what you think best for your setup .. i usually use 3-3-3 or 4-4-4 depending on the part am printing .. use as you see fit ..
i made the face flat to be able to print it and get the pattern to make it look good 
- the red color .. is only one color change ... at specific layer where the Logo starts .. and back to Black. 

NOTE:

1- The blower "Screw ears" should be cut-off to fit the shroud and the front cover should be removed ( like the voron SB shroud ) as you can see the blower with the screw holes cant be fitted within the shroud.. Please take care when cutting the holes as the Typhoon have a solid piece and not hollow .. so it wont be like other blowers.

2- Adding the 5015 Typhoon at the top it will be very close to the Toolhead cabel connector … The cabels should be rearranged as in this image below :

BEFORE

AFTER:

this will allhow to free more space behind the blower… Make sure you dont damage the wires . 

The design started with 2 → 4 Duct .. it was restrecting the flow from the Typhoon .. so i changed it to 2→6 ducts allowed me to get more air speed / flow .. but i feel there is still more could be done to refine this. 

Here are some of the Renders of this Model designed with Kristof . 

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
16.5 MB
Largest file
16.5 MB

0 comments

See all