
Skinny Dart Pusher/Breech cho Nerf Pro Torrent
- Downloads
- 162
- Likes
- 34
- Views
- 1,050
- Remixes
- 1
- Comments
- 0
Files 3 1.5 MB
- Nerf_Pro_Torrent_Skinny_Breech_1773574510.stlSTL · 1.1 MB
- Nerf_Pro_Torrent_Skinny_Breech_1773574511.f3dF3D · 179.8 KB
- Nerf_Pro_Torrent_Skinny_Breech_1773574512.stepSTEP · 225.8 KB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #251565
- Category
- DIY
- Published
Description
Hello everyone! This is a 3D printed replacement dart pusher/breech for the Nerf Pro Torrent that allows for magazine swapping without needing to prime the blaster. While you can load and unload a magazine in a stock Torrent without priming the blaster, I didn't like the feeling of flexing internal parts when doing so. Skinny pushers are a quite popular blaster modification, so I was surprised when I went looking for one for the Torrent and found nothing. So, I decided to make one, and here's the result!
This breech replaces the stock breech, and uses the stock o-rings from the stock breech. While the skinny breach does have a slightly thinner air path due to the thinner profile of the breech, no meaningful drop in fps was found when using a stock spring. I recommend printing this part with 100% infill, regardless of print orientation, to increase the strength of this part as much as possible.
I had a lot of fun working on this project, and I hope everyone else enjoys it as much as I have!
A huge thank you to GP3D for testing this part for me!
Print spec
- Formats
- f3dstepstl
- Model files
- 3
- Total size
- 1.5 MB
- Largest file
- 1.1 MB
0 comments
You may also like 12 models
See all-

-

-

-
New -

-

-

-

-

-
New -
New -



