Skip to main content
F3D
Bát rung Harbor Freight 5lb với dung tích lớn hơn 1

1 image

DIY

Bát rung Harbor Freight 5lb với dung tích lớn hơn

By TravisG_276198

Downloads
48
Likes
9
Views
283

Files 1 338.8 KB

  • HF_Tumbler_Bowl_hi-cap_1765697950.stlSTL · 338.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Higher capacity tumbler bowl for the HarborFreight 5lb tumbler.
It is designed to use the original bowls gasket and lid.
This bowl also has a higher side wall angle, increased height of the center post, decreased diameter of center post, higher angle on both the outer wall and inner center post, as well as wall ribs that run all the way from the center of the bowl side to the center post. This adds up to a more turnover of the media leading to reduced tumbling times to achieve the same effect as the original bowl.

I printed the bowl in PLA+, without supports and 25% infill.

Bowl attaches to tumbler with original nylock nut. If you want to wet tumbler with the bowl make sure to add a stainless steel washer and rubber gasket under the nylock nut.

Concept/mybowl based on 

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
338.8 KB
Largest file
338.8 KB

0 comments

See all