Skip to main content
F3D
Núm khóa pin xe đạp điện Wolff (Vela/Vega/Ursa) 1

5 images

DIY

Núm khóa pin xe đạp điện Wolff (Vela/Vega/Ursa)

By Junktech_4346959

Views
65

Files 1 1,011.8 KB

  • Wolff_Ebike_Battery_Latch_Knob_v4_1773533599.stepSTEP · 1,011.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

If you sell, own or work on Wolff brand e-bike, then you have probably seen this knob for the battery release break. The knob just crumbles over time for seemingly no reason. I work for a dealer and own a Vela, when i went to remove the knob to use for modeling, i found it all broken up.  I cut the bottom part off so i could trace it easier.  

If you work for a dealer, you may be able to get a metal knob from Wolff but this works too and doesn't need shipping. 

0.12 layer lines, 100% infill since its so small, print for best look with supports on the bottom surface. Bambu Studio will want it to print vertical but laying down leads to much better quality. Material shouldn't matter, this is a low strength item.

Read more Show less

Print spec

Formats
step
Model files
1
Total size
1,011.8 KB
Largest file
1,011.8 KB

0 comments

See all