Dụng cụ hỗ trợ gắn nam châm Magnet Insertion Tool v2

UPDATE 24.09.2024

• 8x3mm Magnet Variant added (not tested by me as i dont have those magnets. These magnets may be too strong for this variant)

UPDATE 20.09.2024

• 6x3mm Magnet Variant added

INTRODUCTION

v2 of my Magnet Insertion Tool, with

• optimized Tip size
• trigger suspension 
• self reloading Magnet Magazine

PRINTING

All parts are already in the correct orientation. “Tip” is the only part that requires Support Material.

I printed everything in PLA. 0.2mm Layer height, 0.4mm Nozzle on a Anycubic kobra 2 Pro.

FILAMENT

i used PLA+ from Elegoo but any other Pla should work as well

PLA+ from Elegoo (reflink)

HARDWARE

Magnet sizes currently tested and supported:

• 5x1mm
• 6x2mm
• 8x2mm
• 6x3mm
• 8x3mm (not tested)

Other Hardware you need:

• 2x M3x6mm
• 3x M3x10mm
• Rubberband
• 3x Magnets of selected size

ASSEMBLY

There is a PDF attached to the files with assembly instructions as well as some simple Assembly steps shown in the Video

I reccomend printing 2 tools. 1 for each pole of the magnet. I printed one in Red and one in blue.

Support my work by becoming a PATREON

or Buy me a Coffee