
Hộp đạn 9mm x 100 viên Rugged
- Downloads
- 191
- Likes
- 29
- Views
- 1,205
- Remixes
- 0
- Comments
- 0
Files 2 2.7 MB
- 9mm_x_100_Rugged_1772768326.3mf3MF · 1.1 MB
- 9mm_x_100_Rugged_step_1772768328.STEPSTEP · 1.6 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #239620
- Category
- DIY
- Published
- License
- Creative Commons — Public Domain
- Tags
Description
The case is made with PLA for the lid, base and cartridges holder. The gasket is TPU 95 and the latches and hinge pins ASA.
The other items you will require is 4 x 1.6mm finish nail and a 7mm x 20mm spring for the hinges.
The lid has 2 sacrificial hinge shafts that are connected by a small filament inside. When the print for the lid is complete, use a pair of pliers to work the hinge plugs and work them in opposite direction to break the connection filament.
I have made a deep gasket insert this time, so after print carefully trim the excess of the gasket profile.
When I trimmed the nails to length I used a small drop of superglue on each end of the hinge shafts to lock them in place.
The assembly is you insert the springs in the shafts with a hinge pin at each end, the radius facing out. With your fingers depress the hinge pins and then slide the lid to the base assembly and the springs will do the rest. The case will flex enough for you to insert one hinge and load the other and insert it.
I resisted the temptation to use m3 bolts as this I feel is over the top..
As always please leave a comment or suggestion if you decide to print your own case.
Print spec
- Formats
- 3mfstep
- Model files
- 2
- Total size
- 2.7 MB
- Largest file
- 1.6 MB
0 comments
You may also like 12 models
See all-

-

-

-

-

-
New -

-

-

-

-

-


