Skip to main content
F3D
Benchdog MFT 20mm cho Festool, Metabo, Wolfcraft… 1

2 images

DIY

Benchdog MFT 20mm cho Festool, Metabo, Wolfcraft (nhiều kiểu)

By teslapunk

Downloads
450
Likes
138
Views
1,979

Files 7 420 KB

  • Benchdog_8mm_round_1772656246.stlSTL · 74.9 KB
  • Benchdog_15mm_round_1772656247.stlSTL · 74.9 KB
  • Benchdog_30mm_round_1772656248.stlSTL · 43.6 KB
  • Benchdog_8mm_chamfer_1772656249.stlSTL · 69.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

deutsche Version weiter unten / german version below

EN:

This is a collection of MFT benchdogs in various styles, designed for 20mm holes.

The 20mm bolt INSIDE the table is 20mm in length; the usable length ON the table is 8/15/30mm - either round or chamfered, each with a 30mm diameter.

The shorter 8 and 15mm versions feature a channel for attaching a wire, cord, or zip tie, which can be helpful if you prefer a tight fit and need to easily remove the benchdogs. I prefer a tight fit when sawing angles.

The version with the 8.1mm slot is designed for mounting fences or rails…

Caution: While the models are precisely 20mm, your print may vary due to printer tolerances, filament used, and the quality of your MFT holes…so please don’t blame me for any discrepancies. Simply print the 8mm version first and verify that it fits. If not, adjust the X and Y axis scaling in your slicer and try again. Also, your filament’s flow rate might need tweaking.

I utilized a green Bambu PETG Basic, which closely resembles Festool Green. PLA is also a suitable option!

DE:

Dies ist ein Satz verschiedener MFT Benchdogs für 20mm Bohrungen.

Der 20mm Bolzen IM Tisch ist 20mm lang, die nutzbare Länge auf AUF dem Tisch 8/15/30mm - entweder rund oder mit einer glatten Seite, jeweils 30mm im Durchmesser.

Die kurzen 8 und 15mm Varianten haben einen Kanal in dem man einen Draht, eine Kordel oder einen Kabelbinder befestigen kann. Wenn man fest sitzende Benchdogs bevorzugt dann ist das hilfreich diese wieder herauszubekommen. Bei mir ist das der Fall um Winkel exakt zu sägen.

Die Variante mit dem 8,1mm Langloch ist dafür gedacht eine Schiene o.ä. anzubringen.

Achtung: Auch wenn die Modelle exakt 20mm groß sind kann das beim Druck abweichend sein durch die Druckertoleranzen, Filament, Qualität der MFT Bohrungen … also bitte nicht deswegen bei mir beschweren. Einfach als erstes die 8mm Variante drucken und testen ob es passt. Wenn nicht dann im Slicer die X- und Y-Achse skalieren und erneut versuchen. Auch die Flussrate des Filaments könnte angepasst werden.

Ich habe grünes Bambu PETG Basic verwendet, das kommt dem Festool Grün nahe. PLA kann aber auch gut verwendet werden.

Read more Show less

Print spec

Formats
stl
Model files
7
Total size
420 KB
Largest file
74.9 KB

0 comments

See all