Bộ Tool Bảo Trì & Holder cho Bambu A1

Liked the tools I had been finding but it seems I could only locate the axis lubrication tools as a set and the tool to help remove filament tubes separate. I wanted to put them all in a nice set and since I like magnets and am low on ground space made a holder that they slot into using some 10mm x 3mm round magnets and a few 5mm washers. 

My original plan was to just do kind of a copy of pre-existing tools, but I ended up going a step further. I pulled diagrams and dimensions for the actual linear rails and screw rods used in the machine. Then based my designs off of those dimensions. Then many, many, many prototypes later to account for angles and clearance and convenience I settled on the following tools. 

My main goal was to make sure both the x and y axis tools are designed to give as much contact with the interface surface and have a relief cut to help pool and distribute the oil evenly across the surface. Unfortunately for ease of print I decided to leave them all flat on one side so they are directional with these features.