HexiBox Series: Motor

As seen on X and YouTube:

Designed for use with a pair of the Dayton Audio TCP115-8 4" midbass drivers, and a Dayton Audio DS175-PR 6.5" passive radiator.  The two drivers should be wired in parallel, with the forward driver wired out of phase.  Use M4 threaded inserts 6mm deep / 6mm outer diameter, and reusable adhesive to seal around everything.  Set the high pass no lower than 45Hz, low pass around 80Hz.  ~10W should be enough for it to play at volume.  The companion pods should only need a ~100Hz high pass filter.

Midbass Drivers:
https://www.parts-express.com/--295-416

Extended Range Drivers:
https://www.parts-express.com/--295-349

Passive Radiator:
https://www.parts-express.com/--295-498

Threaded Inserts:
https://www.amazon.com/gp/product/B0CS6XGMFD

Screws:
https://www.amazon.com/gp/product/B0BMQ4WV1V

Binding Posts:
https://www.amazon.com/dp/B07PFMD1N2

Recommended printing settings:

PLA is okay; PETG is better.
At least 4 walls (perimeters) all the way around.
At least 20% gyroid infill.  (Higher is better; this thing WILL vibrate.)
Print the handles 100% solid.