
Panel Điện Bedrail Thùng Xe Tacoma (Ổ 12V & Cầu Chì)
- Downloads
- 3
- Likes
- 3
- Views
- 84
- Remixes
- 0
- Comments
- 0
Files 5 1.8 MB
- Tacoma_Bedrail_Drop-In_Nut_1771913134.stlSTL · 37 KB
- Tacoma_Bedrail_Fuse_Panel_1771913134.stlSTL · 148.5 KB
- Tacoma_Bedrail_Switch_Panel_1771913135.stlSTL · 435 KB
- Tacoma_Bedrail_Drop-In_Nut_1771913136.f3dF3D · 104.5 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #226211
- Category
- DIY
- Published
- Tags
Description
I made these panels to add 12V power sockets into my truck bed. Includes a fuse panel and is connected to my chassis battery and an auxiliary battery in the truck bed. The switch panel has 12V sockets and a voltmeter, with 2-position switches that allow me to select where I want to power each item from.
I've also included a dimensionally - accurate profile of a Gen 3 Tacoma bed and bedrail, so you can make your own panels and have em fit. See attached .f3d files to modify in Fusion.
Material Used:
-
Bluesea 5035 Fuse Block (I jumpered groups of 3 fuses together, so I have 3 chassis circuits, and 3 auxiliary battery circuits).
-
Panel mount SPDT switch (these are IP65 rated)
-
8-terminal strip (for ground bus)
-
1/4-20 x 1" bolts for bedrail nuts, plus nylock hardware + fender washers.
Printing Suggestions:
-
Print the switch panel on it's side for maximum strength. You'll only need supports for the very top.
-
Print in PETG -- I used fuzzy skin so it didn't have the shiny layer lines PETG usually gets.
Print spec
- Formats
- f3dstl
- Model files
- 5
- Total size
- 1.8 MB
- Largest file
- 1.1 MB
0 comments
You may also like 12 models
See all-
New -

-

-

-
New -

-

-

-

-

-

-
New

