Skip to main content
F3D
Kẹp Giữ Cọ Sơn Nam Châm Cho Paint Pot (Sơn Nhà) 1

2 images

DIY

Kẹp Giữ Cọ Sơn Nam Châm Cho Paint Pot (Sơn Nhà)

By Turbosol_2577940

Views
40

Files 1 176 KB

  • Paint_brush_clip_with_magnet_1771890129.3mf3MF · 176 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#224937
Category
DIY
Published

Description

This is a new version of my original clip I made to hold paint brushes to your paint pot when not in use so they don't tip and fall into the paint (https://www.printables.com/model/1145930-paint-brush-holder-for-cutpot-house-painting) My original used a clip end, and this new version uses a magnet. This is specifically modeled to fit a Sherwin williams paint pot but I found it fits most other brands too.

 It uses a 12mm x 3mm magnet and an m3x8 tapered flat head screw (the hole on the model for the screw is slightly smaller so that it taps it's own threads in the plastic when you screw it in). Alternatively you could glue the magnet in if you don't want to use a screw. 

 M3x8 tapered flat head screws: https://us.store.bambulab.com/products/m3-flat-head-cap-machine-screws-fhcs?id=42376310096008

 12x3mm Magnet: https://us.store.bambulab.com/products/disc-countersunk-hole-magnet?id=42609628348552

 PRINTING INFO:

Any hard filament should work.

Print on it's side, supports needed and I like to add a little brim or use glue stick at the bottom for extra adhesion but it's optional.

 If you would like to leave a tip for my hard work you can do so here :D  https://www.paypal.com/ncp/payment/Y5DRF7PN8S5AJ

Read more Show less

Print spec

Formats
3mf
Model files
1
Total size
176 KB
Largest file
176 KB

0 comments

See all