
Adapter khay pin 3x AA sang 18650 cho đèn pin
- Downloads
- 5
- Likes
- 1
- Views
- 95
- Remixes
- 0
- Comments
- 0
Files 1 79.4 KB
- Part_Studio_1_-_Part_1_7_1771108375.stlSTL · 79.4 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #219716
- Category
- Dụng Cụ Tiện Ích
- Published
- License
- Creative Commons — Attribution
Description
Li-ion /LifePo4 safety warning
-
For use with “protected” cells only. Unprotected cells can be discharged too much making them hazardous when re-charged.
-
Some flashlights are sealed tubes with o-rings at each end. In the worst-case scenario, a failed 18500 cell can discharge up to ~4 liters of gas. If the o-rings don't release some gas, then the cap will pop off violently when you go to replace the cell potentially causing serious injury.
-
To mitigate these risks, consider removing one or both o-rings if present. Without o-rings, the aluminum threads of cheap flashlights are more susceptible to corrosion, so keep the flashlight away from moisture.
Intro
Many medium size multi-LED flashlights (usually ~50x 3mm LEDs) use a cartridge with 3x AA batteries for 4.5V with alkaline or 3.6V with NiCd/NiMh. These flashlights have a voltage regulator that makes them very forgiving on the input voltage and usually work great with a 3.7V Li-ion cell.
So I made an adapter to help fit an 18650 cell.
Printing
PLA or PETG OK.
CAD
The model is a simple tube with an 18.75mm inner diameter, 29.5mm outer diameter and 63.5mm height. The ends are chamfered for easier fitment.
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 79.4 KB
- Largest file
- 79.4 KB
0 comments
You may also like 12 models
See all-

-
New -

-
New -
New -

-

-

-

-

-

-

