Skip to main content
F3D
Khay Trộn Keo Nhỏ Kèm Spatula Bẻ Rời 1

3 images

DIY

Khay Trộn Keo Nhỏ Kèm Spatula Bẻ Rời

By RetroPurp_4325298

Downloads
24
Likes
10
Views
156

Files 2 83.8 KB

  • Spachtel_1770868024.3mf3MF · 38.4 KB
  • Spachtel_1770868024.stlSTL · 45.4 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

DE:
Dieses kleine Misch‑Tablet mit integrierter Abbrech‑Spachtel ist als praktische Einweg‑Lösung für die Werkstatt gedacht.
Die Mischfläche ist ca. 50×40 mm groß, hat einen umlaufenden Rand von 3 mm Höhe und leicht abgerundete Kanten, damit nichts so schnell herunterläuft. Die Spachtel ist etwa 60×10 mm groß und 1,6 mm dick; sie sitzt über einen ca. 0,6 mm starken Steg am Tablet und lässt sich bei Bedarf sauber abbrechen.

Ideal, um kleine Mengen 2‑Komponenten‑Kleber oder andere Zweikomponenten‑Materialien anzumischen und direkt aufzutragen – zum Beispiel 2K‑Epoxy, wenn gerade keine Mischdüse zur Hand ist. Das Modell ist bewusst als Einweg‑Teil konzipiert: sehr geringer Filamentverbrauch pro Stück und kurze Druckzeit machen es einfach, sich einen kleinen Vorrat anzulegen.

 Das Tablet und die Spachtel werden in einem Stück flach auf dem Druckbett gedruckt, ohne Support und ohne zusätzliche Haft‑Hilfen. Nach dem Druck kann die Spachtel bei Bedarf am Sollbruch‑Steg abgebrochen und separat verwendet werden.

EN:
This compact mixing tray with integrated break‑off spatula is designed as a convenient disposable solution for the workshop.
The mixing area is approximately 50×40 mm with a 3 mm raised rim and slightly rounded edges to help keep liquids on the pad. The spatula is about 60×10 mm and 1.6 mm thick; it is connected to the tray by a roughly 0.6 mm thick bridge so it can be snapped off cleanly when needed.

 It is ideal for mixing small amounts of two‑component adhesives or similar materials and applying them directly – for example 2‑part epoxy when you do not have a static mixing nozzle available. The design is intentionally single‑use: very low filament usage per part and short print times make it easy to print a small stock.

 The tray and spatula are printed as one piece, lying flat on the build plate, with no supports and no additional adhesion helpers required. After printing, simply snap off the spatula at the thin bridge and use it as a separate mixing and spreading tool.

Read more Show less

Print spec

Formats
3mfstl
Model files
2
Total size
83.8 KB
Largest file
45.4 KB

0 comments

See all