Skip to main content
F3D
Antenna GP 1/4 cho Meshtastic 1

1 image

DIY

Antenna GP 1/4 cho Meshtastic

By AndreyLifar_2081652

Downloads
8
Likes
5
Views
131

Files 3 1.4 MB

  • GP_antenna_mount_1770590205.stlSTL · 481.8 KB
  • GP_antenna_main_1770590206.stlSTL · 282.9 KB
  • GP_antenna_holder_1770590207.stlSTL · 635.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#212664
Category
DIY
Published

Description

The assembly is simple. The bottom part has a hole at the bottom for the support rod. The coaxial cable can pass inside the hollow rod, or there is a side hole to route the cable outside. The middle part holds the radial wires. The outer braid of the coaxial cable is soldered to them. It is securely fixed by the top part (screw connection). The top part holds the vertical radiator, to which the center conductor of the coaxial cable is soldered.

The design is intended for a support rod with a diameter of 16 mm (PVC pipe), a vertical wire of 2 mm, and radials with a diameter of 2 mm.

I tuned it to a frequency of 868-869 MHz.
The radial wires ended up being 8.5 cm long. I adjusted the length of the top rod during tuning using a nanoVNA. I started with 9 cm but trimmed off approximately 1 cm.

In my case, this antenna resulted in an SWR of 1.1 and an impedance of around 54 ohms.

Read more Show less

Print spec

Formats
stl
Model files
3
Total size
1.4 MB
Largest file
635.8 KB

0 comments

See all