Skip to main content
F3D
Hex 7mm, Trục Sau & Bánh Xe (OpenRC F1) 1

8 images

DIY

Hex 7mm, Trục Sau & Bánh Xe (OpenRC F1)

Remix of OpenRC F1 car - Xe RC Tỷ lệ 1:10 By DanielNoree

By AaronShoe_4074522

Downloads
1
Views
42

Files 3 1.1 MB

  • Rear_Axle_Keyed_v3_1770089359.stlSTL · 82.7 KB
  • Wheel_Lock_Nut_Hex_Version_1770089360.stlSTL · 49 KB
  • f104_wheels_keyed_v2_1770089361.stlSTL · 1 MB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#209882
Category
DIY
Published

Description

Replaces the original rear axle which is prone to rounding out under loads higher than a brushed motor. This design includes the axle, F104 Rear Wheels, and the Rear Wheel Nuts. Everything should print fine with standard settings.

I recommend printing using PETG or another strong material if you're printing this out. PLA Plus might get you by if you're running lower powered motors (Traxxas Titan 2T or comparable).

I managed to get the car up to it's top speed of about 50 mph or so with a PETG Axle. I ran a Traxxas BL-2S motor and a 2S battery. Just beware of outside temps since 3D prints are brittle at or near freezing temps.

The wheel, axle, and nuts should go on the car just like the original parts. No special assembly instructions needed.

(Yes I see the VFA's on my pictures. I'm working on my print settings to make my parts look better.)

Designed with Autodesk Inventor (Student License)

Modified from the original CAD files by Daniel Noree

Read more Show less

Print spec

Formats
stl
Model files
3
Total size
1.1 MB
Largest file
1 MB

0 comments

See all