Prusa XL Enclosure Camera Remix (bản remix)

The original design is great, go check it out first. I sliced just enough off both halves to make them sit flat on the build plate, enlarged the mounting holes for M3 heat set inserts, enlarged the single mounting hole that holds the camera to the enclosure for a M4 heat set, added some extrusions  to 3 of the 4 standoffs because they broke off when I was removing supports the first time I printed the camera side, and enlarged the USB passthrough hole on the Pi side of the case.

I printed everything out of PETG and used PLA for the supports. The Raspberry Pi Zero 2W is held in with M2.5 bolts threaded into the plastic and the camera module is held in with M2 threaded into the plastic. 

@ToWcH_22147 inspired me with his custom software linked in his original design. I use the full version of MobileRaker with my other printers, but unfortunately it doesn't work with Prusa printers, and Prusa Connect doesn't allow streaming video, only snapshots. So I wrote a program that allows the RPi to connect to MobileRaker to stream video only and simultaneously connects to Prusa Connect to send snapshots. Tpo be clear, there is ZERO control over your printer in MobileRaker. It's just a convent way for me to keep  a live video feed in the same app with my creality printers. 

I uploaded the program to Github. I call it MoonBridge and you can find it here. The installer gives you the option of just installing the necessary files to use MobileRaker, only install the files for Prusa Connect, or install everything. The frequency of snapshot uploads can be adjusted from the installer on initial install and then at will later by running the installer again.