Skip to main content
F3D
Grommet tham số (Parametric grommet) 1

3 images

DIY

Grommet tham số (Parametric grommet)

By gamebofh_1257683

Downloads
6
Views
49

Files 3 256 KB

  • grommet_1769036802.f3dF3D · 75.8 KB
  • grommet_1769036803.stepSTEP · 19.4 KB
  • grommet_1769036804.stlSTL · 160.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#201827
Category
DIY
Published

Description

I was using the (excellent) Parametric Enclosure for mounting some electronics outdoors, and I wanted to be able to tightly seal holes.  Are these seals waterproof?  Probably not to submersion, but I think they'd do a pretty good job in standard environmental conditions.  

Printing

It's a grommet, so you'll want to print it with flexible filament (e.g. TPU) and I've found 10% infill works fine. It should print without support, bottom on the plate.

There is one STL included, but it's for a very specific size, so I don't think it would be very useful for you.  I've included it just as an example.  However both the Fusion360 and step files are included so you can make the sizes whatever you might want.

Details

This design is parametric so that you can change it based on how wide the hole is, how big the cable is, and how thick the material is that the grommet is going into.  Most of the parameters you'll want to change are named user_. 

User Parameters

These parameters are:

  • user_outer_hole_diameter:  The size of the hole you are plugging

  • user_inner_hole_diameter: The size of the cable/whatever you're having go through the center of the grommet

  • user_hole_thickness:  How thick is the material your grommet is plugging?

  • user_gasket_lip: How much material will end up on the outside of the hole on both sides

Working under the assumption that you're shoving a grommet into a hole, the follow are:

  • user_grommet_top_height: The size of the part that is going to be shoved in

  • user_grommet_bottom_height:  The size of the part that is left outside

You can also see all of these annotated on the images.

Additional parameters

Additional parameters you might want to change

tolerance: This just gives a little wiggle room on the gasket.  If you want to YOLO, you can set this to 0.  It currently makes the outer hole this much smaller, and the inner hole this much larger.

split_width:  How wide the split in the grommet will be.  You can't set it to 0 because the extrude then fails.  I could make this a conditional feature if you didn't want the split, but that's a paid feature for Fusion, so never mind.  Plus, I think you want split grommets most of the time anyway.

Read more Show less

Print spec

Formats
f3dstepstl
Model files
3
Total size
256 KB
Largest file
160.8 KB

0 comments

See all