
Cửa pin thay thế cho đèn flash Yongnuo YN465
- Downloads
- 17
- Likes
- 9
- Views
- 216
- Remixes
- 0
- Comments
- 0
Files 3 89.6 KB
- yn465_door_with_support_1767797708.stlSTL · 33.7 KB
- yn465_door_1767797710.stlSTL · 30.6 KB
- yn465_door_v2_1767797711.stlSTL · 25.3 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #1996
- Category
- Dụng Cụ Tiện Ích
- Published
Description
My YN465 flash took a dive off a lightstand a few years ago and the battery door broke, I kind-of got it to stay in place and it worked until last week when it finally failed.
So I designed this replacement door, this is a new design and not a model of the original door - I made it easier to 3D print than the original design.
I only tested it on the YN465 but it will probably fit all the YN4xx models with the annoying sliding door.
The door has electrical contacts, I used a conductive band (probably copper) from an old broken power strip, there are slots in the model to hold them in place.
Print in 100% infill and support touching buildplate (the small "tooth" at the far side requires support but if you add support everywhere it will fill the little slots for the conductive bands).
I printed in PLA (because I had black PLA available), sliced with Cura and printed on my Robo3D R1+
Update
Cura decided this model does not need auto-generated support, Cura was very wrong and my batteries were very on the floor.
I've added a version with supports, the support doesn't touch the side of the door so it doesn't leave a mark when removed, use a sharp knife of a small wire cutter to remove the support from the tooth
Update 2
I wrote a long explenation but thingiverse logged me out and deleted it, so here's the really short version
- PLA not durable enogth, I switched to nylon, other materials (like ABS) would probably be ok
- I made a 2nd version, it connects better
Category: Camera
Print spec
- Formats
- stl
- Model files
- 3
- Total size
- 89.6 KB
- Largest file
- 33.7 KB
0 comments
You may also like 12 models
See all-
New -

-

-
New -

-

-

-

-

-

-

-
New

