Vỏ (case) Picoducky

Print:

• btn x2

• case x1

• cap x1

or just print the case_together file

Supports aren't really needed, print everything standing up vertically

To assembly:

• First insert the 2 buttons through the case, you may have to cut of a bit of the edges to get it to fit.

• Hold the case upside down to prevent buttons from falling out

• Carefully slide the picoducky in, too much force may cause components on board to break

• Cut a small piece of filament (1.75mm) and slide it into the center hole through the case and the ducky to secure

• Snap on the outer cover by lining up the holes!