Skip to main content
F3D
Giá treo lưỡi cưa lọng T-Shank cho Wall Control Pegboard Mo… 1

1 image

DIY

Giá treo lưỡi cưa lọng T-Shank cho Wall Control Pegboard Mount

By Yangorang

Downloads
205
Likes
37
Views
1,163

Files 1 74.1 KB

  • Jig_Saw_Blade_Wall_Control_Holder_1767913128.stlSTL · 74.1 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#197931
Category
DIY
Published

Description

Holder that I use to mount jig saw blades (T shank) on Wall Control pegboard with well nuts. The blades are held at an angle such that they can be read for easy identification and spacing is wide enough so that you can grab individual blades fairly easily. The fitment around the blades may be a bit on the tight side for you as I didn't want mine wobbling around. There is a small recess for the well nuts such that the holder mounts perfectly flush against the panels.

This should work for any 0.25" pattern pegboard as well. Well nuts are overkill since you don't really need that much strength, but I just like my holders to be nice and tight up against the panels.

Updated 8/10 with slightly wider slots based on measurements from a Bosch T-Shank blade instead because I realized the Ryobi jig saw blades are garbage and don't even hold tightly into their own jig saws.

Well Nuts: https://www.amazon.com/gp/product/B08LCRBS4S/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

Use #6-32 x 1-¼"L bolts for mounting:
https://www.ebay.com/itm/154145272749

T-Shank Blade Set Pictured:  https://www.homedepot.com/p/RYOBI-All-Purpose-Jig-Saw-Blade-Set-10-Piece-A14AK101/315966845

I am not sure how standardized the dimensions on these blades are, but even the metal blades within the same set are slightly thinner than the wood ones and therefore are a looser fit.

Well Nuts Update 12/31/2025
I have finally located a suitable supplier for mounting these to Wall Control and will sell them here:
https://www.ebay.com/itm/147064927166
Note that these will not grip properly onto standard wood Pegboard.  The brass threaded insert is a bit too thick and doesn't allow for gripping onto thicker panels, but they are perfect for thin sheet metal such as Wall Control.  For Pegboard you can potentially use the 1" or so long well nuts from McMaster, but this will then require that you have your Pegboard some distance away from the wall so you're not screwing into it.

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
74.1 KB
Largest file
74.1 KB

0 comments

See all