Skip to main content
F3D
Bản lề (hinge) Leifheit Pegasus – Leifheit Pegasus hinge 1

2 images

Đồ Gia Dụng

Bản lề (hinge) Leifheit Pegasus – Leifheit Pegasus hinge

By JakeTWC_1986180

Downloads
4
Likes
5
Views
100

Files 9 1.4 MB

  • leifheit_pegasus_200_compatible_hinge_1767734677.3mf3MF · 286.4 KB
  • Part_Studio_1_-_arm-right_1767734678.3mf3MF · 39.4 KB
  • Part_Studio_1_-_arm-right_1767734678.stlSTL · 115 KB
  • Part_Studio_1_-_arm-left_1767734679.stlSTL · 115 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#195524
Category
Đồ Gia Dụng
Published

Description

The hinge of my wife's Leifheit Pegasus broke on one side. I looked at existing parts, but found none that i found suitable. There are a lot of designs that are in one part, but this weakens the part one way or the other. I made my replacement part in two pieces.  IT IS IMPORTANT TO PRINT THE ARM UPRIGHT AND NOT ON IT'S SIDE. the two parts interlock. I put them together with hot glue and a screw. The hole for the screw is in the drawing so i does not need to be drilled. The screw cannot be longer that 25mm (the length of the head of the screw excluded)

In the picture i had to use another screw because i didn't know how to remove the iron rod from the original hinge. The trick is to push it out from the inside out. The iron rod isn't screws in and can be pushed through. So now you know.

Printing is best done with petg or other strong material. No supports are needed for printing these parts.

Read more Show less

Print spec

Formats
3mfstl
Model files
9
Total size
1.4 MB
Largest file
304.9 KB

0 comments

See all