KLP1-230 Easy Print Cover và Ring Fan

Print Material : ASA Recommended. PETG will do for lower temps/quick needs to print an ASA version.

Remix of 2 models on makerworld. Improvements made for easier printing and/or alignment and strength.

The fan was redesigned as the original seemed to be based on the use of a printed cover that had flexed when screws were tightened down. To fix this, I have changed the case holes to through holes so screws can be secured in front to the cover then the fan and cooler slot on and tighten down behind with nuts on the opposite side.

The additional benefit of this is no need to cut sections out of the fan screw holes to make it fit the cover anymore; everything is flush.

Cooler still compatible with stock metal cover. Fan used now is a 5015 Fan for better cooling, not the stock fan.

Note: Holes in case a 2.3mm and need the prepwork of a M3 tap. This is to allow the creation of as much thread in the plastic as possible.

Printing Notes: Support is only needed for the 45 degree slant and the overhang next to it. BLOCK support under the cooling ring so air holes don't get filled in accidentally. Tree supports should need even less work.

Fan Duct: increased circle center area by 2mm in Y axis; shifted circle blower location 0.5mm to center ring around nozzle; tapered end of cooler for better fitment in tight space

Cover: Increased body thickness to 2.4mm for greater stability; changed hex-holes to 45 degree slat holes; changed screw mounts to thru screw holes; added side mount for 30x30mm fan for cooling THR Board (DIY jst 2.0 Y-splitter cable needed to use fan, connect with extruder fan so it is always on when the nozzle is hot)