
Khoan jig cho mdf/bảng 18mm
- Downloads
- 0
- Likes
- 0
- Views
- 0
- Remixes
- 0
- Comments
- 0
Files 2 648.5 KB
- 18mm_mdf_drill_jig_2mm-6mm_1767687839.3mf3MF · 130.8 KB
- 18mm_mdf_drill_jig_2mm-6mm_1767687840.stlSTL · 517.7 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #19011
- Category
- DIY
- Published
Description
I'm doing a project that requires joining mdf boards, and found myself looking for a way to make sure I was centred on my 18mm board. This model has a right angle lip to line up against the edge and 2mm, 3mm, 4mm, 5mm and 6mm drill bit holes. It should work any time you want a hole centred 9mm from the edge.
Print on the thick side with the holes running parallel to the build plate. I used organic/tree supports in PrusaSlicer and it worked well. I tried printing in other orientations, but ended up with bad surfaces either touching the wood (made alignment tough) or the top (made the numbers hard to read).
Printed on Ender 3 S1 Pro (Sonic Pad) with Sunlu PLA and:
- 0.2mm layers
- 3 perimeters, 3 top/bottom layers
- 10% infill
- Organic Supports
- 200mm/s perimeters, infill
- 150mm/s external perimeters
- 40mm/s supports
- Though actual speeds were mostly in the sub 100mm/s range based on the size of the layers and travel
- 6000 accel
Print time: 1 hr 2 min
21.4 g of filament
Print spec
- Formats
- 3mfstl
- Model files
- 2
- Total size
- 648.5 KB
- Largest file
- 517.7 KB
0 comments
You may also like 12 models
See all-

-
New -
New -

-

-
New -
New -
New -
New -

-

-
New

