Skip to main content
F3D
Case compact pin 18650 cho Heltec V4 (Heltec Lora32 V4) 1

7 images

DIY

Case compact pin 18650 cho Heltec V4 (Heltec Lora32 V4)

By nonsintetic_3028580

Downloads
24
Likes
9
Views
279

Files 4 19.1 MB

  • main-body_1767387684.3mf3MF · 33.1 KB
  • endcap_1767387685.3mf3MF · 5.6 KB
  • buttons_1767387685.3mf3MF · 2.4 KB
  • HeltecV4-case_1767387686.f3zF3Z · 19 MB

Make a variant with AI

Build another version of this model.

Open Studio

Description

I wanted a portable case for my new Heltec Lora32 V4 board. I like to cram as much stuff inside a small case as possible. This one supports their GPS board, an 18650 cell connected directly to the port on the board. There's also a magnet depression where you can glue on some thin magnets.

I didn't include an on/off switch since you can hold down the user button to soft-shutdown the node. A power button would need to be on for charging and that just seems janky to me. If you want an on/off button there's a sketch for it in the Fusion360 file, the extrude for the hole is disabled for the main export, you can turn it back on and adjust the hole to your liking.

No hardware is required, just a dab of superglue to stick the buttons onto the case.

Print the piece with the buttons with no supports and the bridge vertical, use maximum cooling fan speed and slow print speed to keep it from warping, this is by far the trickiest part of the build to print. I believe in you!

BOM:

  • Heltec V4 board

  • 18650 maybe with a protection board (you decide your level of safety)

  • SMA pigtail

  • (optional) their GPS module board (sticks to the side of the case in a recess)

  • maybe a spot of glue if the cap isn't tight enough for your liking

Fusion360 source files included. They're messy, you have been warned.

Read more Show less

Print spec

Formats
3mff3z
Model files
4
Total size
19.1 MB
Largest file
19 MB

0 comments

See all