
Tay dẫn ống PTFE Bowden Voron và hỗ trợ cáp CANBUS
- Downloads
- 7,512
- Likes
- 471
- Views
- 17,891
- Remixes
- 2
- Comments
- 0
Files 13 13.6 MB
- Bowden_Guide_V2_1767377472.stepSTEP · 1.4 MB
- Bowden_Guide_V2_1767377473.f3dF3D · 3.3 MB
- Mount_1767377474.stlSTL · 68.5 KB
- Mount_Bearing_1767377475.stlSTL · 89.6 KB
Make a variant with AI
Build another version of this model.
Remix versions 2
RR V-Core 4 Bowden PTFE Tube GuideByaxel_1049406 · 04/20/2026
Beefy Voron PTFE bearing mountByprimate · 01/03/2026
Details
- Model ID
- #187817
- Category
- Máy In 3D
- Published
- License
- GNU General Public License v3.0
Description
V2- PTFE bowden tube guide and CANBUS wire support
**** 7NOV24 -Removed a zip tie hole on the long arm's that was a weak point ****
I've made some adjustment after some feedback from the community.
Changes made over V1:
- Added a option to have F695 bearings incorporated
- Enlarged the tube opening
- Added cable/zip tie openings
- Added spot for 1mm piano wire if needed.
Recommended print settings:
- Voron print settings (4 walls, 40% infill and 5 top and bottom layers)
- Turn off thin walls
- Bridge setting: keep only bridges (watch out for bridging for cable tie holes)
- 0.2mm layers and 0.2mm first layer
- No need to adjust for ABS shrinkage
Required Hardware:
- M3x8 Bolt and M3 T-nut
- M5 bolt to suit option.
- Optional M5 nut if you can fit it with the bearing option.
V1 - PTFE bowden tube guide and CANBUS wire support
This is can found inside the zip files and of the initial release
Required Hardware:
- M3x8 Bolt and M3 T-nut
- M5x10 Bolt or a M5x8/12
- Optional 4mm drill bit for cleaning out bowden tube path
About
In my 350 build the PTFE tube kept getting caught so I made this arm to keep it up. The shorter arm works better so I recommend using it instead
The setup has also been used by a few user to support their CANBUS wires (zip tied to the reverse bowden)
Install
- Drill out bowden guide with 4mm drill bit for a perfect fit (optional)
- Bolt mount to rear frame with M3x8 and tnut putting the lip at the top
- Screw arm on with M5x10 (I used a M5x8mm and it works fine) into the plastic allowing the arm to still be able to swivel
Print spec
- Formats
- 3mff3dstepstlzip
- Model files
- 13
- Total size
- 13.6 MB
- Largest file
- 3.3 MB
0 comments
You may also like 12 models
See all-

-

-
New -

-

-

-

-
New -
New -
New -

-


