Neptune 4/pro/Plus/Max Fanmod by layer.shifted

Fits all Neptune 4 variants. 

This fan-mod targets to provide better cooling then stock while sticking loosly to the stock design language while integrating 2x 5015 Fans and 1x4015 Fan. There is a PDF with assembly instructions. It also tells about the different variants you could go for.

This was testprinted several times on an Neptune 4(non Pro). It has to be said that you have to have your Printer and Filament dialed in very well as the tolerances of some of the Parts are fairly tight. This was necessary to get a decent rigidity despite the relatively low weight.

It was designed to fit Sunon/Winsinn 5015 Fans as well as gdsTime and Elegoo 4015 Fans.
If you stick to the Elegoo Fan Version you will not require any additional screw. The are reused from stock ones. The only thing additionally required will be jst 1.5. connectors for the Sunon fans and switching of pins on the 4015 Fan as this is reversed on the Extruder Board.

note on 5015: Sunon(18-24v) are slightly quieter - Winsinn has better operating voltage range(3-24v)

*.3mf: Sliced with Orca 2.2.0 for Neptune 4 with PETg
Other Slicers: Take settings from PDF

latest Version

v113 (only changed files will be updated)
Changelog is in the PDF

-----
Feel free to buymeacoffee.com/lamarc