
K2 Lid Riser - Nâng Nắp Có Lỗ Thông Hơi Đóng Mở
- Downloads
- 400
- Likes
- 47
- Views
- 2,488
- Remixes
- 0
- Comments
- 0
Files 10 262.5 KB
- K2_Riser_-_Front-Rear_Slide_Vent_1767170606.stlSTL · 24.5 KB
- K2_Riser_-_Corner_1767170607.stlSTL · 11.4 KB
- K2_Riser_-_Side_Vent_1767170608.stlSTL · 35.4 KB
- K2_Riser_-_Side_Slide_Vent_1767170609.stlSTL · 24.5 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #186519
- Category
- Máy In 3D
- Published
Description
A simple K2 lid riser with closable vents. I couldn't find a riser for the K2 that I like so I set about designing a simple low profile riser. The main reason for this was to stop the PTFE tube at the hotend rubbing on the glass top when it was printing. The riser is a nice tight fit in to the frame of K2 and the glass is also a snug fit
You will need to print the following:
4x Corners
2x Front-Rear Vent
2x Side Vent
2x Front-Rear Slide Vents
2x Side Slide Vents
Assembly:
Connect the Front-Rear Vent and Side Vents to the Corner pieces, then slide the Front-Rear Slide vents inside the Front/Rear vents. Then slide the Side Slide Vents in to the Side Vents.
Print recommendations:
I recommend printing in ASA or PETG
I would suggest a minimum of 10% Gyroid infill
3 Perimeter walls
There are 2 versions I have uploaded:
K2 Riser: has tight tolerances and may require a little sanding to get it to fit together
K2 Riser Loose: has bigger tolerances and may be a little slacker and a bit more forgiving for printer tolerances
Print spec
- Formats
- stl
- Model files
- 10
- Total size
- 262.5 KB
- Largest file
- 35.4 KB
0 comments
You may also like 12 models
See all-

-
New -
New -

-

-

-

-

-

-

-

-


