Vỏ case QMTech MiSTer FPGA loại nhỏ

The STLs includes: Case Top, Case Bottom and Buttons. Make sure to print 3 of the buttons.

Also, you will want to add supports to the top of the VGA cutout. Please see photos for details.

To assemble you will remove the screws from the top and bottom of the QMTech PCB case. These are m3 x 5mm screws. Should be 8 total. Keep these as we will reuse them. The QMTech buttons have colored toppers on them. Remove and set aside as they will not be used again. Add the new printed square button toppers on top of the tall tact switch. Install the top shell piece VGA port side first and then lower down the USB port side making sure the buttons are lined up with the cutouts. The fit will be snug due to the USB ports. Install 4 of the screws in the top.

Now you can simply flip it over and install the bottom shell piece and secure it with the last 4 screws. Add some rubber feet to the bottom and you are done.