
Người giữ Spool Spool cho bản phối lại EIBOS
Remix of Người giữ Spool cho Eibos - Phù hợp với nhiều ống By Fercik_318466
- Downloads
- 0
- Likes
- 0
- Views
- 0
- Remixes
- 0
- Comments
- 0
Files 2 1.5 MB
- Tush_Bolt_circle_cutout_1767010930.stlSTL · 939.8 KB
- Tush_Bolt_hex_cutout_1767010931.stlSTL · 598.8 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #18545
- Category
- DIY
- Published
Description
The original remix uploaded by Fercik was good, but made some modifications. The spool holder no longer requires washers and the spools will stay on the bearings as they had a tendency to fall off with Fercik‘a version.
This version uses 3x10x4 bearings .
Parts used:
bearing 3x10x4 - x10
M3x30mm bolt - x3
M3x20mm standoff
M3 Nuts x 4
Print 2 of each model in petg
Note - if you offset the bearings like I did in the photos there will be no need to adjust the spool holder.
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 1.5 MB
- Largest file
- 939.8 KB
0 comments
You may also like 12 models
See all-
New -

-

-

-
New -
New -
New -

-

-
New -

-
New

