
Heltec Wireless Stick (Lite) v3 case
- Downloads
- 530
- Likes
- 0
- Views
- 0
- Remixes
- 0
- Comments
- 0
Files 5 992.8 KB
- top_wireless_stick_1766809308.stlSTL · 304.8 KB
- top_wireless_stick_lite_1766809309.stlSTL · 278 KB
- mid_1766809310.stlSTL · 213 KB
- base_1766809311.stlSTL · 195.6 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #18186
- Category
- DIY
- Published
Description
Heltec Wireless Stick (Lite) v3 case
Parts needed:
- Heltec Wireless Stick v3, either in the Lite or "normal" version including the antenna cable.
- 4 ruthex style M3 inserts, d=4.6mm, h=5.7mm
- 4 M3x12 screws, all kinds with flat heads should work fine
Building
Print the parts, the button twice. 0.2mm layer height or better is recommended.
Supports are only needed for the screw holes of the top part. Print without supports otherwise, rotate the parts so you don't need supports.
In case the top layers are not 100% flat, use a fine sandpaper until they are. Add the inserts, some sandpaper and/or a file might also be needed to make the surface on top of them flat again. Add the board and antenna cable (use the connector next to the USB port for LORA!) and close the case with the 4 M3 screws.
Battery support
I might add a case with battery support on request. Let me know.
Sources
Are here on github: https://github.com/bzed/openscad-parts/blob/main/heltec_wireless_stick/case.scad - please send pull requests.
License
Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International Public License - no, you can't sell it. But feel free to remix and share under the same license.
Print spec
- Formats
- stl
- Model files
- 5
- Total size
- 992.8 KB
- Largest file
- 304.8 KB
0 comments
You may also like 12 models
See all-

-

-

-

-

-

-
New -

-

-

-

-


