
Đế Kẹp Ống Pony Jorgensen
- Downloads
- 222
- Likes
- 74
- Views
- 1,142
- Remixes
- 0
- Comments
- 0
Files 2 7.9 MB
- Stand_end_1766763089.stlSTL · 2.9 MB
- Stand_screw_side_1766763090.stlSTL · 5 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #179485
- Category
- DIY
- Published
Description
The stands prevent Popy Jorgensen pipe clamps from falling over constantly. They also elevate the clamps slightly.
Part A keeps the clamps upright and must be placed on the screw side. Part B is the end support and can be placed anywhere along the pipe near the sliding end.
The stands are used with the ¾ inch (20mm) pipe clamp fixture.
Printing tips
Take note of print orientation and support in images - prints must lay down flat on the print bed.
Supports: paint supports only on bottom of protrusion for Part A and use normal supports (not tree) for smoother result. Part B doesn't need supports.
First layer and top surface: 0.36mm
Infill: Cubic 15%
Printed in PETG, but PLA will also work. Watch out for too much layer cooling to prevent warping.
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 7.9 MB
- Largest file
- 5 MB
0 comments
You may also like 12 models
See all-

-

-

-

-

-

-

-
New -

-
New -

-
New

