
Cờ lê tháo nắp lọc dầu Colorado/DMax 50mm
- Downloads
- 99
- Likes
- 9
- Views
- 1,107
- Remixes
- 0
- Comments
- 0
Files 1 543.8 KB
- Fuel_Filter_Wrench_50mm_1766359795.stlSTL · 543.8 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #17940
- Category
- DIY
- Published
- License
- Creative Commons — Public Domain
Description
This is simple wrench for removing/tightening the fuel filter housing cap on a Holden RC Colorado and Isuzu DMax (2008-2011), where the filter is located underneath the vehicle next to the LHS chassis rail. The wrench has a hex nut of 50mm to slip over the filter housing cap once the sensor wire is removed, and the short handle allows it to fit between the chassis rail & torsion bar and turn approx 70deg
The label on the filter advises tightening to 25Nm of torque. I wasn't sure what infill should be okay but to be confident with the wrench strength, I set my print to 40% infill, 5 perimeters, 5 Top/Bottom layers and there was only minimal bending of the tool/handle when used.
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 543.8 KB
- Largest file
- 543.8 KB












