
Mô hình F-111 CSB "SN-6" | Máy bay RC EDF đôi
- Downloads
- 181
- Likes
- 34
- Views
- 1,091
- Remixes
- 0
- Comments
- 0
Files 2 5.7 MB
- F-111_CSB_SN-6_Printables_Release_1766692620.3mf3MF · 3.2 MB
- F-111_CSB_SN-6_Printables_Release_Arranged_1766692621.3mf3MF · 2.5 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #177682
- Category
- DIY
- Published
Description
This Project contains the files for my “SN-6” F-111CSB Prototype.
It has already been flight tested successfully.
Specifications:
Channels: 3-4
Wing Span: 83cm
Weight: 600g (300g printed parts)
Thrust: 700g
T/W Ratio: 1.17
Battery: 4S 1300mAh LiPo
Engines: 2x40mm X-Fly Galaxy X4 EDF (5000kV)
Servos: 2xGeneric 9g Servo
Flight Time: ~3min
Gyro Required: No
Recommended Print Settings:
Filament: LW-PLA (eg Colorfabb LW-PLA/LW-PLA-HT, eSUN ePLA-LW)
Temp: 230-250C
Flow: 45%-55%
Infill: 4%-6% Gyroid
Speed: 25mm/s-40mm/s
Acceleration: as high as possible to reduce stringing
Line Width: 0.5mm Outer Walls, 0.4mm-0.6mm Infill
Retractions: off
Avoid Crossing Perimeters: on
Required Components:
Carbon Rods: 2x 2x95mm, 1x 3x800mm, 1x 3x480mm
Servos: 2xGeneric 9g Servo
EDFs: 2x 40mm X-Fly Galaxy X4 EDF (5000kV)
ESCs: 2x30A or better (eg Flycolor Francy 2 30A)
Battery: 4S 1300mAh LiPo
Control Linkages: ~400mm
Cover B: 4x 4x8mm Round Magnets
Cover A: 2x bendable steel wire
Notes:
- The Tailerons are very sensitive in the Pitch axis, but not very effective in the roll axis
- LiPos bigger than 4S 1300mAh can fit in the model. though it was never tested with a larger battery pack
- CG marks are found at the bottom of the wing parts
- The plane flies very fast at full throttle
- Parts can be printed on an Ender-3 sized printer or larger (220x220x250)
- all parts can be printed without supports
- i highly recommend to gain experience by flying other EDF jets before this one. it's not super hard to fly but also not easy
- i miscalculated the Thrust and therefore Thrust/Weight ratio in the video. it's not 1.67. it's actually closer to 1.17.
Print spec
- Formats
- 3mf
- Model files
- 2
- Total size
- 5.7 MB
- Largest file
- 3.2 MB
0 comments
You may also like 12 models
See all-

-

-

-

-

-
New -

-

-

-
New -

-
New

