Hộp TS101

What we will need:

 - 6x M3x20 screw

 - 1x M3x14 screws

 - 1x M3 hex nut

 - 1x 608 bearing

 - All printed files (soldering wire spool; clampers are needed 2 times)

 - Glue (optional)

Assembly Instructions for the TS101 Box

 - Insert the 608 bearing into the holder and secure it with 1 M3x14 screw and an M3 hex nut.

 - Place the upper inside part into the top part (with the logo). Optionally, use a small amount of glue to secure it in place.

 - Secure the 2 clampers to the box using 2 M6x20 screws. Tighten them just enough so the clampers can spin freely.

 - Place the lower inside part into the bottom part. Optionally, use a small amount of glue to secure it in place.

 - Assemble the top part and bottom part by securing them with 2 M3x20 screws. Tighten them evenly, but don’t overtighten to avoid cracking the parts and make sure they spin smoothly.

 - Screw in 2 M3x20 screws just enough so the clampers can lock the box.