Miếng Đệm Quạt Máy Tính

This is a computer fan spacer that adds a 16.5 offset and is 140mm wide and designed to hold fan screws 125mm apart. I designed it against my Lian Li Uni Fan SL-INF 140 RGB Fans 

I made this as my Lian Li fans side mirrors were not visible before and I wanted to offset the fans down below the case edges. In addition, for my Lian li case, the rear fan did not fit well as it was 4mm to wide, so offsetting beyond the case bevel fixed that problem as well.

Designed to be used with 50mm m3 or m4 screws that pass all the way through, with a nyloc lock nut on the end. Only two screws are needed if you place them diagonally. The screw holes are 5.0mm in diameter.

In the slicer you could easily change the Z on this to increase or decrease the offset amount, and use with a different length screw.