Chân đế cân bằng Harman Kardon Rabco ST-8

This is a replacement foot for the Harman Kardon Rabco ST-8 linear turntable. While the original used a "knurled" rubber band, the replacement has the knurling modeled into the part, as the rubber part is hard to find.

Print in your favorite filament, open side down. Use paint-on supports for the center. For best results:

• layer height 0.15

• infill 40%

After printing use a sharp knife to remove any "elephant foot" blocking the threads. Add a 3/4" felt dot to complete the part.

The HK-foot-male model is a tool that can be used to make sure the threads are clean before installation. Discard after use.