[REMIX] Đầu in Bambulab cho Stealthburner

BOM:

1. Same with original model.
2. You might require to replace one of the square nut with normal nut.

How To:

1. Remove the supports from REAR part. They should came out easily. [3 pieces in total.]
2. Slide hotend to rear part.
   
3. Put nut for the left one first, then tighten the screw.(I could not fit square nut in here but normal nut works as well.) Then do the same for right one.(You can use square nut in for right screw.) Do not torque the screws yet; tighten them loose them back ~half turn.
   
4. Slide small, printed part.
   
5. You can tighten the screws now. 
6. Complete assembly with FRONT part.