Bộ chuyển đổi gắn khớp cho Logitech C910

This is a remix for mounting a Logitech C910 webcam. For a custom look, I lofted it to align with the back of the C910 geometry once the stock hardware is removed.

Hint - you have to peel back most of the padding to get to the screws, then pry it open until you can wiggle the camera from the little white plastic retention pieces.

Hardware Required:
-(1) M4x25 socket cap screw (purchased at HD)
-(1) M4 nut...I used a hex, but square should work as well (purchased at HD)

The .f3d file is included in case you want to tinker some more.

Print instructions

Orientation - Lay the flat part that contacts the C910 on the bed.

Layer Height - .10 to the transition to the ball adapter at ~7.9 mm, then .20 for the rest.

Material - Prusament Galaxy Black PETG

Perimeters - 3

Infill - 15% Gyroid

Supports - I did not use supports and it bridged well enough with PETG.