
Pétanque/Boules Jack
- Downloads
- 63
- Likes
- 4
- Views
- 360
- Remixes
- 0
- Comments
- 0
Files 3 7.6 MB
- petanque_jack_parts_1767555397.stlSTL · 6.1 MB
- petanque_jack_parts_1767555398.3mf3MF · 1.5 MB
- petanque_jack_1767555399.scadSCAD · 2.8 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #139787
- Category
- Thể Thao & Ngoài Trời
- Published
Description
This is a Pétanque Jack that prints in two halves, to ensure it prints cleanly without supports on an FDM printer. No extra hardware or glue is required - the two halves screw together using the printed stud.
The jack is the regulation 30mm in diameter, and if printed with 100% infill it will print with the regulation weight of between 10g and 18g (PLA/PETG comes out at ~15g, ABS ~12g).
Just don't print it in Grass Green if you're planning to play in a campsite field ;) I created this model to replace such a green jack that was lost in the grass.
Print Settings
Print the stud with a layer height of 0.2mm, and the jack halves with 0.2mm up to a height of 10mm, then 0.1mm for the top 5mm to minimise the steps between layers where the hemisphere flattens at the top. A 5mm brim for the stud will prevent it from falling over during a fast IS print - give the brim a 0.2mm separation gap to make it easy to remove.
I have included a 3MF file that includes these settings. I have reduced the filament ‘Extrusion multiplier’ to 0.9 to ensure there are no problems with the 100% infill.
The top surface of the female thread in the jack half will bridge quite easily without supports, and the thread is deep enough that a small amount of filament sagging will not prevent the stud from screwing in far enough.
I have also included the OpenSCAD script that I used to produce this model. It uses Ryan Colyer's OpenSCAD ‘Threads’ module.
Print spec
- Formats
- 3mfscadstl
- Model files
- 3
- Total size
- 7.6 MB
- Largest file
- 6.1 MB
0 comments
You may also like 12 models
See all-

-
New -

-

-

-

-

-

-

-

-

-


