Kẹp giữ ống Bowden và cáp CANbus / USB

Bowden tube and CANbus cable support clips.

Oftentimes switching from conventional setup of gazillion wires into cable chains is a bit tough as there are certain challenges with this.

Small things can make big difference.

Challenge this simple thing is addressing and solving more than effectively is how to organise bowden tube and CANbus / USB cable sagging and prevent it getting damaged on toolhead movements.

Dimensions

• 4mm OD, 2.5mm ID, 16mm of length
• 4mm OD, 2.5mm ID, 8mm of length

BOM (bill of materials)

Printed Parts

• Printed parts 2 - 4 clips, depending on the size of your printer and therefore - bowden tube and cable length.
   

PRINT GUIDELINES

Here are print guidelines for you to follow in order to have decent success with printing parts:

3D PRINTING PROCESS

FDM (fused deposition modeling)

INFILL TYPE

Grid, Gyroid, Honeycomb, Triangle or Cubic

MATERIAL

Enclosed printer — ASA, ASA-CF, ABS, ABS+, ABS-CF

Un-enclosed printer — PLA, PLA+ or PETG

INFILL PERCENTAGE 

40% - 60%

LAYER HEIGHT

Recommended: 0.2mm

WALL COUNT 

Recommended: 4

SOLID TOP/BOTTOM LAYERS

Recommended: 5

EXTRUSION WIDTH

Forced 0.4mm

Side notes to the print guidelines

A wall count of 4 is an absolute must to ensure the structural integrity of the parts. There is no need to go over the top with this. 4 walls are perfectly fine for this model.

CHANGELOG

Date

Change

28.01.2024

Initial version (Rev1)