
Giá đỡ cuộn filament gập cho Bambu Lab X1C và P1P
Remix of Giá đỡ cuộn dây gập cho máy in Bambu Lab X1C P1P By Ebolo
- Downloads
- 0
- Likes
- 0
- Views
- 0
- Remixes
- 0
- Comments
- 0
Files 5 4.9 MB
- bambu_spool_holder_back_offset_V2_1766106405.stlSTL · 439.9 KB
- spool_holder_mount_1766106406.stlSTL · 48.1 KB
- bambu_back_offset_roller_holder_1766106407.stlSTL · 2.9 MB
- bambu_back_offset_spool_roller_1766106408.stlSTL · 1.4 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #12569
- Category
- Máy In 3D
- Published
- License
- Creative Commons — Attribution
Description
This is a simple remix of Ebolo's Foldable Side spool mount for X1C and P1P.
My printer shelf has more room at the back then side of printer, so this one is a back mount that offsets the spool holder near machine center, so I can remove spool from the spool mount without hitting the shelf column.
I have also added a few holes to the offset mount that holds the alien wrench and nozzle needle.
Very situational, but if you have a shelf like mine it might be useful for you.
----- 2023-08-11 -----
I have added a V2, which secures the mount to the top center screw at the back of the machine.
The main reason for this redesign is:
- the old mount is showing some small deformation - the arm is longer, and the PLA I use is not strong enough to hold full spool without deform. It likely is not a major issue, as I can see it won't deform further, but the top mount method should eliminate the worry that spool might fall out mid print.
- The back of my machine is getting a bit busy now. PTFE Wye, split coupler.. etc. I need more room in the original corner where the spool holder was mounted with V1.
----- 2023-08-28 -----
Added a compact roller, remixed from suit's compact filament roller.
I made some modification as while suit's model uses 8x22x7 bearing (608), I only have 5x16x5 bearing (625).
So this roller is even smaller than suit's roller, and it can be added directly onto my v2 design and still folds up.
I think I finally is happy with the back filament mount design now..
Print spec
- Formats
- stl
- Model files
- 5
- Total size
- 4.9 MB
- Largest file
- 2.9 MB
0 comments
You may also like 12 models
See all-

-

-

-

-

-
New -

-
New -

-

-

-


