Tua Vít Đa Năng Cho Bu Lông Multiboard

This is a remix of "Screw Driver" by megatron321

( https://www.thingiverse.com/thing:709811 )

0.2mm quality No supports needed if printed vertically

This screw driver has been adapted to drive MULTIBOARD bolts and T-Bolts. After installing and removing so many multiboard bolts, my fingers hurt terribly so I created a tool to easily install and remove the bolts. It is designed to fit both plain and flat bolts as well as plain and flat t-bolts.

I added grooves along the head to indicate the sides of the bolts to assist with lining them up with the multiboard tiles. There are two smaller grooves that indicate the top/bottom points of the t-bolts.

I added a custom brand to the handle base. The file does not have the brand.

I printed this standing up on the base and used a Brim to keep it in place. If you want to deal with more supports, you can print it in its side so the layer lines are perpendicular to the torque direction but I haven't had any structural issues.