
Vỏ và nắp cho nút bấm - Ender 3
- Downloads
- 18
- Likes
- 5
- Views
- 299
- Remixes
- 1
- Comments
- 0
Files 3 2.1 MB
- base_1768172681.stlSTL · 1.3 MB
- base_left_single_1768172682.stlSTL · 702.8 KB
- cover_1768172683.stlSTL · 65.3 KB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #124169
- Category
- Máy In 3D
- Published
- License
- Creative Commons — Attribution
- Tags
Description
This is a small box that houses 2 push buttons, with covers. The base can be attached in front-right of an Ender 3 (pro), just in front of the LCD, using the existing 2 screws at the end of the 40x40 rail.
These buttons are hooked up to a Raspberry Pi that runs OctoPrint which controls my printer. One button is a cancel button, the other runs a 'reset wifi' script (the wifi on the RPi can be quite flakey at times). I designed this to have covers because I did not want to accidently press one of them during a print.
This is designed to use these buttons, but I expect any similar size button should work.
For reference, those buttons have a diameter of ~6.75mm (where the threads are) and are about 12mm tall from the base of the threads.
Printing Notes:
Print 1 base and 2 covers of desired colors. The covers should easily snap onto the base and move freely.
No supports required. The base can be printed upright, as-is. It should not require supports or a brim unless you are having adhesion issues.
The cover was designed to be printed with a 0.4 nozzle in a specific orientation. It should not require supports or a raft, but a brim could be helpful if adhesion is an issue:
(closer view)
Print spec
- Formats
- stl
- Model files
- 3
- Total size
- 2.1 MB
- Largest file
- 1.3 MB
0 comments
You may also like 12 models
See all-

-
New -
New -

-

-

-

-

-

-

-

-



