Skip to main content
F3D
Vỏ Raspberry PI 5 Lắp Ghép Mô-đun Kèm Hộp Đựng SSD 1

4 images

Dụng Cụ Tiện Ích

Vỏ Raspberry PI 5 Lắp Ghép Mô-đun Kèm Hộp Đựng SSD

Remix of Hộp Raspberry Pi 5 - Lắp ráp mô-đun By Jascha3D

By Aonne_548072

Downloads
191
Likes
18
Views
1,701

Files 3 12.4 MB

  • pi5_ssdslot_1765833916.stlSTL · 497.2 KB
  • pi5_top_1765833917.stlSTL · 10 MB
  • pi5_bottom_1765833919.stlSTL · 1.8 MB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#123704
Published

Description

The TOP and BOTTOM files replace the designs from the original, They are essential the same just wider to match the SSD Enclosure. 

Also the BOTTOM has holes underneath for the SSD enclosure to clip into.

The insert for the top is the same as the original model so they are not included here.

The SSD enclosure is the only model that needs support - and only touching baseplate for the screw holes.

I printed all 4 parts in 0.28 layer height, 0.48mm line width (with a 0.4mm nozzle), 2 walls, 2 top layers, 2 bottom layers, 15% grid infill.

I didn't intend to print with 0.48mm line width! the setting was left over from a previous model… so 0.4mm line width would be fine - as would pretty much any number of walls, top/bottom and infill setting you like (as long as there is some infill).

The SSD enclosure is a tight fit to snap on and isn't designed to be disconnected. It does have screw holes to secure the ssd drive, but I didn't need to use them as the ssd drive has a snug fit.

Read more Show less

Print spec

Formats
stl
Model files
3
Total size
12.4 MB
Largest file
10 MB

0 comments

See all