Giá đỡ Raspberry Pi Zero và Camera Module 3 Wide cho Hộp đựng Prusa

A holder for a Raspberry Pi Zero and a Raspberry Pi Camera Module 3 Wide in an original Prusa Enclosure. Attaches to any vertical beam using the screw hole in the bottom half of the beam.

For fixing, requires one M3x screw with a head of your liking (I used a spare socket cap screw) and a M3nS M3 nut (5mm side, M3 thread).

The camera case requires two hex M3 nuts and two M3 screws to close.

The Zero holder will snap onto the leg with the model's connectors. The hole closer to the edge of the holder should be facing toward the top of the enclosure if the holder is in the bottom half of the beam. The indent in the holder is intended to avoid the cable tie holder in the enclosure.