
Còi Nhà Thờ (Church Whistle)
Remix of Whistle By F3D Team
- Downloads
- 27
- Likes
- 3
- Views
- 257
- Remixes
- 0
- Comments
- 0
Files 2 131.7 KB
- church_whistle_1765835112.stlSTL · 82.3 KB
- church_whistle_petg_1765835113.3mf3MF · 49.4 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #123242
- Category
- DIY
- Published
- License
- Creative Commons — Public Domain
Description
(english below)
Eine nützliche Pfeife, die auf der originalen von Prusa basiert. Mit einem kleinen Ring, den man sowohl um den linken als auch um den rechten Zeigefinger tun kann, ist man auf der nächsten Demo gegen rechts super ausgestattet. Da ich bei der Kirche arbeite, ist ein Kreuz als Logo dabei.
Die Pfeife kann gut mit PLA oder PETG ohne Stützen gedruckt werden. Ich habe gute Erfahrungen mit PETG, 0.6n Düse und 0.4mm DRAFT Einstellung gemacht. Damit ist jede Pfeife in ca. 14 Minuten gedruckt. Auf ein typisches MK3S Druckbrett passen 18 Trillerpfeifen - ca. 3h Druckzeit.
Teil von #pfarrpersonengegenrechts - https://epstr.de/metablabla
#######
A useful whistle based on the original one from Prusa. With a small ring that you can put on both your left and right index finger, you are well equipped for the next demo against facism. Since I work at the church, there is a cross as a logo.
The whistle can be easily printed with PLA or PETG without supports. I have had good experiences with PETG, 0.6n nozzle and 0.4mm DRAFT setting. This means that each pipe is printed in about 14 minutes. A typical MK3S printing board fits 18 whistles - approx. 3 hours of printing time.
Part of #pastorsagainstfacism - https://epstr.de/metablabla
Print spec
- Formats
- 3mfstl
- Model files
- 2
- Total size
- 131.7 KB
- Largest file
- 82.3 KB
0 comments
You may also like 12 models
See all-

-

-
New -

-

-

-
New -

-
New -
New -
New -


