Giá Gắn GoPro Cho Máy AnkerMake M5C

Summary

This was designed to hold a GoPro camera at a 90 degree angle on the right z-axis of an AnkerMake M5C for timelapses. The GoPro mount was remixed from this mount but has been scaled up by 2% to fit better. 

Note: While designed to be screwed in, the mount is tight enough to support at least a GoPro Hero 8 without any nuts and bolts but I haven't tested other newer GoPro models.

I added a small square of foam underneath the “M” logo to cushion the print so that it wouldn't make noise when printing and fit extra snug.

Print Settings

Printer:

AnkerMakeM5c

Rafts: 

No

Supports:

Yes

Resolution: 

0.2mm

Filament:

Generic PLA

Print Notes: 

Print between 2-3x's speed as I had some issues with supports falling off when printing at the default 5x mode.